Close the Access Cover. Normal printer operating mode. For additionalinterfacing requirements, see thetable below. In orderto operate the printer, you will need to remove the tape and foam placed therefor shipment. Referto your font supplier for information. The selectable modes Ready, Menu and QuickTest and the related functions of the printer keys are detailed below. Page 4 Agency Compliance and Approvals:
|Date Added:||5 April 2018|
|File Size:||14.26 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Try the suggestions inSection 2.
Lowercasealpha names will print barcodes only. Using the Front Panel4. Select this optionif MOP is not needed. Using a soft bristle brush orcompressed air, clean out the interior of the printer. In addition, eachof the following adjustments has no factorydefault setting and restoring factory defaultswill NOT affect these settings.
Or, for continuous media: Pressing again will return the printer to normaloperation. Remove the media fromthe Media Sensor thenpress any key. If print quality remains unacceptable, an adjustmentmay be required. Page The table below lists the font sizes; the numbers indicate the number of dots.
This information is displayedhere; it is also printed on a configurationlabel.
This manual provides all the information necessary for everyday printeroperation. Unlock the Printhead Latch and raise the PrintheadAssembly. DHCP is enabled by default. As an example, this would beentered as: If the problempersists, call for service. Label formats interpreted as intendedfor DPI.
The Configuration Label content can vary with the application versionand printer model. Light print on the right side facing the printer of thelabel: Remove media and ribbon.
Then, as the media is pulled through the printer, the particlescan become attached and cause voids on the printed labels. From the resulting list, findthe largest DifferenceValue see example below. To save a manually entered setup for example, an application that required anAdvanced Entry Calibration before beginning as a configuration file using thefront panel: If multipleWarnings are detected, the display will reflect the highest priority message.
Performthis calibration during initial set-up or after changing your media type. Your manual failed to upload For information on messages, see Section 6. To begin printing labels, refer to the instructions provided with thelabel-creation software you have chosen.
These are the DifferenceValues. Standard and Advanced Entry. Appendix BAvailable Fonts and Bar CodesAll character fonts and bar codes available with the printer are described in thissection. Consult the Programmer’s Manual for detailed information. Adjustthe Sensor Eye Markover the center of thefacedown black mark.
Increasingthis value causes more energy to be transferred to the media, resulting in adarker image. Printer completes label batch withoutpausing between labels.
Normal power-up and Occurs when the usersoft reset condition.